Ceiling Fan Not Controlled By Switch

If you are using a remote or.

Ceiling fan not controlled by switch.

Confirm the reverse switch is not in a neutral position. So now i am stuck. Now that the ceiling fan is in one of the switches does nothing and the other controls both the ceiling fan and light fixture. Use a toothpick to change one of the little switch settings.

The two switches controlled two different ceiling light fixtures. The ceiling fan will be hardwired and controlled by the pull cord. Or the fan can stop responding to the remote control because of frequency issues. It does not control any wall plug outlet nor any wires in the ceiling box.

If the receiver in the fan fails the remote will not work. The remote module has a set of small dip switches on the side of the module. Before it was just a light fixture and it was controlled from a switch on the wall. Flip the switch several times to make sure it is the right.

What are my options to get the wall switch to control the ceiling fan light fixture. A wall switch which over rides the remote i e if the wall switch is turned off the fan and the light would turn off. Typical ceiling fan remote control modules are located above the ceiling fan support bracket in the ceiling. Follow the steps below to determine the cause.

The ceiling fan w light are controlled by a remote control device. Changing the frequency in the ceiling fan remote control module. The remote may also stop working because the battery power is low. Test to determine whether the batteries are dead.

Ensure that the fan s receiver and dip switches behind the remote are on the same frequency. Minka aire ceiling fan remote control not working remove the back of the batteries to check if you have inserted them correctly. And the switch must be turned on for the fan and or light to respond to the remote. For example it may fail to turn the fan on or off.

If you have an older ceiling fan the switch may be worn out. If the switch fails to operate the fan try pulling the fan chains first. If the fan still fails to operate and. Suddenly the fan is stuck in low speed and the light won t turn on.

In this case replace the reverse switch.